Trane Furnace 3 flashes
What this problem usually means
Trane uses this flash count on two different control families, so note which LED is flashing (red LED = single-stage control; green LED = two-stage control). On single-stage furnaces (XR80, XR90, XR95, XB80, XB90 families) with the integrated furnace control (IFC), 3 flashes means a pressure switch fault — the draft pressure switch did not prove proper inducer draft as expected. On two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2), 3 flashes means the first-stage pressure switch is stuck open or there is an inducer error — draft was not proved for first-stage heat.
Likely causes
- Blocked or frozen vent or intake termination
- Clogged or frozen condensate drain or trap
- Weak or failed inducer motor
- Failed pressure switch (the first-stage switch on two-stage models) or cracked pressure hose
How to fix it — step by step
- Check the outdoor PVC intake and exhaust terminations and clear snow, ice, leaves or debris you can safely reach
- Check the condensate drain hose and trap for kinks, clogs or freezing
- Confirm the thermostat is calling for heat and the furnace switch is on
- Reset power once (off 30 seconds, then on) and watch whether the code returns
- If it returns, call a technician to test the inducer, pressure switch and venting — do not bypass the switch
Parts that commonly fix it
- pressure switch - Shop at RepairClinic
- inducer motor - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.