Bosch Washer E:36 -10 Error Code
What the E:36 -10 code means
The detergent solution is not being pumped out — on current five-digit-display models this is the drain fault also shown as E:18 on other models.
Likely causes
- Drain pump blocked
- Drain pipe or outlet hose blocked
- Outlet hose kinked, trapped, connected too high (over 1 metre) or extended with an unapproved extension
- Pump cover not correctly assembled or pump cap not fully screwed in
- Detergent dosage too high causing oversudsing
How to fix it — step by step
- Switch off and unplug the washer
- Check the outlet hose installation: no kinks, no unapproved extensions, and no higher than 1 metre
- Clean the drain pipe and outlet hose
- Open the service flap, drain the water into a shallow pan, clean the drain pump and make sure the pump cap is screwed fully in with its handle vertical
- Reduce the detergent dose if there was heavy foaming, then run a drain programme to test
Parts that commonly fix the E:36 -10 code
- drain pump - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.