Bosch Washer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 18 codes covered.
Shop Bosch Washer parts at RepairClinic
- E16 — The washing machine door is open or has not latched properly, so the programme cannot start or continue.
- E17 — The water supply time has been exceeded — the washer is filling too slowly or not filling at all.
- E18 — The washer is not draining — Bosch lists a blocked drain pump, a blocked or kinked drain hose, or oversudsing as the causes. It is also…
- E19 — The water heating time has been exceeded — the washer could not heat the water to the set temperature in the allowed time. Bosch states…
- E20 — Unexpected heating — the washer is heating water when it should not be, for example during a rinse or a cold programme.
- E23 — The AquaStop leak-protection system has been activated, which usually means water has leaked into the base of the washer. Bosch states this…
- E25 — The turbidity (Aqua) sensor is faulty — the sensor that measures how dirty the wash water is is not reporting correctly. Bosch states this…
- E26 — The analogue pressure sensor is faulty — the sensor that measures the water level in the drum is not working. Bosch states this fault…
- E28 — The flow sensor is faulty — the sensor that measures water flowing into the washer is not reporting correctly. Bosch states this fault…
- E29 — Too little water is reaching the washer — Bosch groups E29/F29 with its water-inlet faults: the inlet or AquaStop filters are blocked or…
- E31 — The maximum water level in the drum has been exceeded — the washer has overfilled or believes it has. It is also shown as F31 or E00-31.
- E32 — Unbalanced load detected — Bosch says this is not a fault: the unbalanced-load system interrupted or skipped the spin because the laundry…
- E43 — A motor circuit fault — the drum motor is not turning correctly or the control is not getting the expected signal from it. Bosch lists…
- E57 — The motor inverter is abnormal — the electronics that drive the drum motor have detected a fault and stopped the machine. Bosch lists…
- E:35 -10 — The appliance is leaking — there is water in the base trough and the leak protection has stopped the machine. On some models this…
- E:36 -10 — The detergent solution is not being pumped out — on current five-digit-display models this is the drain fault also shown as E:18 on other…
- F27 — The pressure sensor is faulty — the washer cannot reliably measure the water level in the drum. Bosch states this fault cannot be rectified…
- F34 — The washing machine door cannot be locked, so the programme will not start. Bosch manuals list this as 'Cannot lock washing machine door'.