Trane Furnace E08 Error Code
What the E08 code means
On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E08 means flame current is low but still strong enough to allow operation — the furnace may run, but the weak flame signal will eventually cause shutdowns.
Likely causes
- Dirty or oxidized flame sensor
- Poor burner ground
- Weak flame from dirty burners
How to fix it — step by step
- Replace the air filter and confirm registers are open
- Note whether the furnace short-cycles or drops out mid-cycle
- Book a technician visit soon — the furnace is warning before it fails
- A technician will clean or replace the flame sensor and verify flame current
Parts that commonly fix the E08 code
- flame sensor - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.