Trane Furnace E2.2 Error Code

What the E2.2 code means

On Trane S-series furnaces with a seven-segment display (S9X1, S9X2, S9B1 and S8X1, S8X2), code E2.2 is recycles exceeded — flame was sensed then lost repeatedly (one-hour lockout after 10 recycles).

Likely causes

  1. Dirty flame sensor dropping the flame signal
  2. Low or unstable gas pressure
  3. Dirty burners or poor burner ground

How to fix it — step by step

  1. Replace the air filter and open all registers
  2. Reset power once after the lockout and watch one full cycle
  3. Note whether the burners light and then go out within seconds
  4. Call a technician to clean/test the flame sensor and check gas pressure if it recurs

Parts that commonly fix the E2.2 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Trane furnace error codes

See all Trane furnace codes & guides →