Payne Furnace 27 Error Code
What the 27 code means
Super plug program fault on Payne furnaces with a 3-digit status display. The program in the super plug is missing, not recognized, or corrupted (minor codes 27.1 through 27.3), so the control cannot run its heating program.
Likely causes
- Super plug missing
- Super plug program not recognized or corrupted
How to fix it — step by step
- Note the code for the technician
- Do not remove or swap plugs inside the control yourself
- Leave the furnace off if it will not run
- Call a technician - the control must be reprogrammed or the super plug replaced by a dealer
Parts that commonly fix the 27 code
- control board - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.