OBD-II Car P0446 Error Code
What the P0446 code means
Evaporative Emission System Vent Control Circuit Malfunction: the vent valve - which closes to seal the EVAP system so the computer can leak-test it - or its control circuit has an electrical fault. The computer sets this code when it sees an open, a short to ground, or a short to battery voltage on the vent valve circuit, or when the system can't achieve or hold vacuum during its test. (Some scan tools mislabel this code as a purge flow fault; the SAE fault is the vent control circuit.)
Likely causes
- Faulty EVAP vent valve/solenoid (most likely)
- Open, short, or high resistance in the vent valve control or power circuit
- Vent valve physically blocked - dirt, dust, or insect nests in the vent filter/hose are common on trucks
- Failed PCM driver (rare - rule everything else out first)
How to fix it — step by step
- Locate the vent valve (usually at the charcoal canister, under the rear of the vehicle) and inspect it and its fresh-air filter/hose for dirt blockage - clean or clear it
- Inspect the connector and wiring for corrosion, rodent damage, and pushed-out pins
- Test the valve: it should click when 12V is applied and seal when energised; check its coil resistance against spec
- Repair any open, short, or high-resistance wiring you find
- Replace the vent valve if it fails the bench test - this is the fix in most cases
Parts that commonly fix the P0446 code
- EVAP vent valve solenoid - Shop at Amazon
- vent valve filter - Shop at Amazon
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.