OBD-II Car P0441 Error Code
What the P0441 code means
Evaporative Emission Control System Incorrect Purge Flow: the computer commanded the EVAP purge valve open but detected no (or wrong) vapour flow from the charcoal canister to the engine. Unlike the leak codes, this one is about flow, not sealing - think stuck valve, blockage, or a dead control circuit. Usually the only symptom is the check engine light.
Likely causes
- Faulty purge solenoid - stuck closed, or stuck partially open
- Restriction or blockage in the EVAP line, canister, or solenoid
- Broken or damaged EVAP line or cracked canister
- Open or short in the purge solenoid's power feed or the PCM's command circuit, or corrosion in its connector
- Bad vacuum switch (on systems that use one to detect flow)
- On Chrysler vehicles, a failed leak detection pump (LDP) is a common fix
How to fix it — step by step
- Inspect the EVAP lines and canister for damage, kinks, and disconnected hoses
- Test the purge solenoid: unpowered it should be closed (hold vacuum); apply 12V and it should click open and pass air - replace it if it fails either way
- Check the purge connector for corrosion and verify power and the PCM ground signal reach the solenoid
- Blow out or repair any restriction in the EVAP line or a clogged canister
- Clear the code and complete a drive cycle - EVAP monitors need specific conditions (fuel level between roughly 1/4 and 3/4, a cold start) to rerun
Parts that commonly fix the P0441 code
- EVAP purge solenoid - Shop at Amazon
- charcoal canister - Shop at Amazon
- leak detection pump - Shop at Amazon
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.