Kenmore Washer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 18 codes covered.
Shop Kenmore Washer parts at RepairClinic
- dE — Door open error on Kenmore 796-series (LG-built) front-load washers: the control thinks the door is open, so the cycle will not run.
- EE — EEPROM error on the main electronic control board on Kenmore 796-series (LG-built) front-load washers: the control board memory is…
- F20 — No water detected entering the machine on Kenmore 110-series (Whirlpool-built) high-efficiency front-load washers. The pressure switch is…
- F21 — Long drain on Kenmore 110-series (Whirlpool-built) high-efficiency front-load washers: drain time exceeds about 8 minutes and the water…
- F33 — Pump drive system error on Kenmore 110-series (Whirlpool-built) high-efficiency washers: the connection between the drain pump and the…
- FE — Water overflow error on Kenmore 796-series (LG-built) front-load washers: the water level is too high.
- IE — Inlet water supply error on Kenmore 796-series (LG-built) front-load washers: the expected water level is not reached in 8 minutes, or the…
- Ld — Long drain on Kenmore 110-series (Whirlpool-built) Oasis top-load washers: the washer is taking too long to drain water from the tub. Sears…
- LE — Locked drive motor error on Kenmore 796-series (LG-built) front-load washers: the motor cannot turn the drum. On 796 top-load models LE can…
- LF — Long fill on Kenmore 110-series (Whirlpool-built) Oasis top-load washers: the washer is taking too long to fill with water. Sears…
- OE — Slow drain on Kenmore 796-series (LG-built) front-load washers: the washer is not draining, or is draining too slowly.
- oL — Overload on Kenmore 110-series (Whirlpool-built) Oasis top-load washers: the washer tried to fill and start, found the load too heavy, and…
- PE — Water level sensor failure on Kenmore 796-series (LG-built) front-load washers: the control cannot read the water level correctly.
- PF — Power failure on Kenmore 796-series (LG-built) front-load washers: power was lost during the cycle, so the cycle may not have completed…
- Sd — Excessive suds on Kenmore 110-series (Whirlpool-built) Oasis top-load washers. The control detects too much foam and runs a suds reduction…
- tE — Heating sensor (thermistor) error on Kenmore 796-series (LG-built) front-load washers: the water temperature sensor reading is out of range.
- UE — Unbalanced load on Kenmore 796-series (LG-built) front-load washers: the load could not be balanced for spin. On 796 top-load models the…
- uL — Unbalanced load on Kenmore 110-series (Whirlpool-built) Oasis top-load washers. The washer runs an imbalance correction routine at the end…