Carrier Furnace 31 Error Code
What the 31 code means
Pressure switch did not close or reopened. On single-stage Carrier furnaces such as the 58ST this is the main vent pressure switch; on two-stage models code 31 is the high-heat pressure switch or relay (see code 32). If the switch stays open longer than 5 minutes, the inducer shuts off for 15 minutes before retrying.
Likely causes
- Blocked or restricted intake or exhaust vent (snow, ice, leaves, nest)
- Plugged condensate drain or trap
- Disconnected or obstructed pressure tubing
- Defective inducer motor
- Defective pressure switch
How to fix it — step by step
- Check the outdoor PVC intake and exhaust pipes and clear any snow, ice, leaves or debris you can reach
- Check the condensate drain line and trap for a clog or standing water
- Check and replace a dirty air filter
- Turn power off for one minute and back on for one retry
- If 31 returns, call a technician - never jumper a pressure switch
Parts that commonly fix the 31 code
- pressure switch - Shop at RepairClinic
- inducer motor - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.