Whirlpool Dishwasher F6 E3 Error Code

What the F6 E3 code means

Excessive suds / low water level: the wash pump is drawing less power than expected, usually because suds or too little water are in the tub.

Likely causes

  1. Regular dish soap or too much detergent creating suds
  2. Low water level from a clogged filter or weak fill
  3. Bowls or pans loaded face-up holding water and lowering the tub level

How to fix it — step by step

  1. Scoop out suds and standing water with towels or a wet vac
  2. Use only dishwasher detergent, in the correct amount, and check the rinse aid cap is on
  3. Clean the filters and reload face-up bowls so they do not trap water
  4. Run an empty cycle to clear remaining suds

Parts that commonly fix the F6 E3 code

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Whirlpool dishwasher error codes

See all Whirlpool dishwasher codes & guides →