GE Dishwasher 815 Error Code

What the 815 code means

On GE GDF, GDT and PDT-series dishwashers from the mid-2010s, 815 appears in Consumer Error Mode (holding Cycle Select and Start for 5 seconds) and indicates the Current Sense Module (CSM) has tripped or the main control module has failed, often alongside a blinking Start light and a door-status test failure.

Likely causes

  1. Tripped Current Sense Module (CSM) from a motor current fault
  2. Failed main control module
  3. Door latch not signalling closed
  4. Circulation pump motor fault

How to fix it — step by step

  1. Turn off power at the breaker for about 5 minutes, then restore it
  2. Enter Consumer Error Mode (hold Cycle Select and Start for 5 seconds) and run the door status check: lights should be solid with the door closed and flash with it open
  3. If the lights flash with the door closed, the door latch is not signalling; if a new latch does not fix it, the control module has failed
  4. Contact service if 815 will not reset, since the fix is control module replacement

Parts that commonly fix the 815 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related GE dishwasher error codes

See all GE dishwasher codes & guides →