Electrolux Washer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 18 codes covered.
Shop Electrolux Washer parts at RepairClinic
- E10 — The washing machine is not filling with water properly, or is filling too slowly to start the wash.
- E11 — The washer is not filling with water during the washing phase of the cycle (fill difficulty / long fill time).
- E13 — Water leak detected: water is leaking from the tub or the pressure system while the washer runs.
- E20 — The washer is not draining, or is draining too slowly, within the programmed time.
- E21 — Drain fault: the washer has detected that water is not draining after the wash phase when moving to rinse.
- E23 — The drain pump triac (the electronic switch that powers the drain pump) on the control board is faulty.
- E24 — Fault in the sensing circuit of the drain pump triac: the control board is getting the wrong signal from the pump circuit.
- E31 — The electronic (analogic) pressure switch circuit is faulty, so the washer cannot measure water level correctly.
- E32 — The electronic pressure switch has a calibration problem: its reading is unstable or out of range, often during draining.
- E35 — Water overfill: the pressure sensor has detected that the water level in the machine has exceeded normal levels.
- E38 — The pressure sensor detects no change in water level during washing, which usually means the pressure chamber or its tube is clogged.
- E40 — Door lock fault group: the door is not closed properly or the door lock is not engaging, so the washer will not start.
- E41 — The control board thinks the door switch is open, or the door lock timed out without confirming the door is shut.
- E42 — Door lock device failure: there is a problem closing or opening the door lock, and the door may stay locked or fail to lock.
- E51 — The motor power triac on the electronic controller is short-circuited, so the motor cannot be controlled safely.
- E52 — No signal from the motor tachometric generator: the control board is not receiving motor speed feedback.
- E62 — Overheating during washing: the water temperature rose too high (above about 88 degrees C) during the wash.
- EF0 — Aqua control / leak warning: the machine has detected water where it should not be, too much foam, or a badly unbalanced load on some…