York Furnace 3 red flashes

What this problem usually means

The pressure switch contact did not close after the inducer was energized on York furnaces with the red/green/amber LED control, so ignition does not start.

Likely causes

  1. faulty inducer motor
  2. blocked vent pipe
  3. broken pressure switch hose
  4. faulty pressure switch
  5. blocked condensate drain on condensing models

How to fix it — step by step

  1. Check the thermostat is set to Heat and calling for heat
  2. Check the outdoor vent and intake pipes are clear of snow, ice or debris
  3. On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
  4. Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
  5. If the code returns, stop resetting and call a licensed HVAC technician

Parts that commonly fix it

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related York furnace problems

See all York furnace codes & guides →