Shark Robot vacuum CLEAN (BLUE) + DOCK (RED) solid

What this problem usually means

Error number 14 in Shark IQ / EZ manuals: BotBoundary error. The robot is on or too close to a BotBoundary magnetic boundary strip.

Likely causes

  1. Robot started on top of a BotBoundary strip
  2. Robot too close to the magnetic boundary strip to navigate away
  3. Boundary strips set up incorrectly

How to fix it — step by step

  1. Pick the robot up off the boundary strip
  2. Move it to a flat surface well away from the magnetic boundary strip
  3. Check the boundary strips are laid out correctly
  4. Try cleaning again

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Shark robot vacuum problems

See all Shark robot vacuum codes & guides →