Rheem Furnace 57 Error Code

What the 57 code means

Pressure switch stuck open when it should be closed on Rheem furnaces with the 7-segment diagnostic display. The inducer ran but draft was not proven.

Likely causes

  1. blocked vent or excessive vent length/elbows
  2. clogged condensate drain
  3. weak inducer motor
  4. blocked heat exchanger or faulty pressure switch

How to fix it — step by step

  1. Check the thermostat is set to Heat and calling for heat
  2. Check the outdoor vent and intake pipes are clear of snow, ice or debris
  3. On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
  4. Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
  5. If the code returns, stop resetting and call a licensed HVAC technician

Parts that commonly fix the 57 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Rheem furnace error codes

See all Rheem furnace codes & guides →