Rheem Furnace 13 Error Code

What the 13 code means

Flame lost on Rheem furnaces with the 7-segment diagnostic display. Flame was established and then lost during the heating cycle; five losses in a row cause a one-hour lockout with code 10.

Likely causes

  1. dirty flame sensor
  2. low gas pressure
  3. faulty gas valve
  4. interrupted gas supply

How to fix it — step by step

  1. Check the thermostat is set to Heat and the furnace power switch and breaker are on
  2. Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
  3. Turn power off for 30 seconds, then back on, and allow one retry cycle
  4. Do not keep resetting a furnace that repeatedly fails to light
  5. If it locks out again, call a licensed HVAC technician and note the code

Parts that commonly fix the 13 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Rheem furnace error codes

See all Rheem furnace codes & guides →