Rheem Furnace 2 blinks

What this problem usually means

Pressure switch circuit open on older Rheem/Ruud furnaces with the blinking status LED board. Draft was not proven, commonly from venting or condensate problems in winter.

Likely causes

  1. blocked vent
  2. blocked pressure switch port
  3. weak inducer motor
  4. clogged condensate drain backing into the switch hose

How to fix it — step by step

  1. Check the thermostat is set to Heat and calling for heat
  2. Check the outdoor vent and intake pipes are clear of snow, ice or debris
  3. On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
  4. Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
  5. If the code returns, stop resetting and call a licensed HVAC technician

Parts that commonly fix it

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Rheem furnace problems

See all Rheem furnace codes & guides →