Raypak Pool heater Hi Limit 2 is open
What this problem usually means
On Raypak Digital gas pool heaters (206A-406A), Hi Limit 2 is open means the second high-limit safety circuit has opened, usually because water through the heater got too hot or flow was too low. On ASME models this is a manual-reset fault cleared with the MODE button.
Likely causes
- low water flow through the heater
- dirty filter
- internal bypass or unitherm governor problem
- faulty high limit switch
How to fix it — step by step
- Turn the heater off and let it cool
- Confirm the pump runs through the whole heat cycle and clean the filter
- Check valves are fully open
- On ASME models only, press MODE once to reset after cooling
- If it trips again, stop and call a pool technician
Parts that commonly fix it
- high limit switch - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.