OBD-II Car P0301 Error Code

What the P0301 code means

Cylinder 1 Misfire Detected: the engine computer has determined cylinder #1 is not firing properly. Because the fault is tied to one cylinder, the cause is usually a part that serves only that cylinder - its spark plug, coil, or injector - rather than a system-wide problem. Don't just replace the plug and hope: the free swap test below pinpoints the bad part.

Likely causes

  1. Worn or fouled spark plug, or damaged plug wire/boot on cylinder 1
  2. Failed ignition coil for cylinder 1
  3. Clogged or failed fuel injector for cylinder 1
  4. Vacuum leak at the intake port for cylinder 1
  5. Low compression on cylinder 1 - burned exhaust valve, worn rings, or head gasket (less common, test last)

How to fix it — step by step

  1. Pull the cylinder 1 spark plug and read it: worn, oil-fouled, or fuel-soaked plugs tell you a lot; replace plugs if they're due
  2. Swap test the coil: move cylinder 1's ignition coil to another cylinder, clear the code, and drive - if the misfire code follows the coil (e.g. becomes P0302), the coil is bad
  3. If spark is good, swap or test the cylinder 1 injector the same way, and listen for its click with a stethoscope or long screwdriver
  4. Check for a vacuum leak around cylinder 1's intake runner
  5. If spark and fuel both check out, run a compression test on cylinder 1 versus its neighbours - low compression means internal engine work

Parts that commonly fix the P0301 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →