LG Washer IE Error Code
What the IE code means
Inlet error: the washer did not fill with enough water in the time allowed, so the cycle stops.
Likely causes
- Water taps not fully open or a water outage
- Inlet hose kinked, bent or frozen
- Clogged inlet filter screens in the supply hoses
- Low household water pressure
- Drain hose installed too low or submerged, siphoning water out as it fills
How to fix it — step by step
- Fully open both hot and cold water taps and check water runs in the house
- Straighten any kinks in the inlet hoses and make sure they are connected tightly
- Turn off the taps, disconnect the hoses and clean the small inlet filter screens with a toothbrush
- If hoses or taps are frozen, thaw them with warm (not boiling) water or a warm towel
- Make sure the drain hose end is not submerged and is secured at the correct height, then restart the cycle
Parts that commonly fix the IE code
- water inlet valve - Shop at RepairClinic
- inlet hose - Shop at RepairClinic
- inlet filter screen - Shop at RepairClinic
- water level pressure switch - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.