Lennox Furnace 1 + 2 Error Code
What the 1 + 2 code means
On Lennox G61MPV furnaces with the SureLight control, flash code 1 + 2 means low flame current in run mode — the flame signal is weak while the furnace is running.
Likely causes
- Dirty or oxidized flame sensor
- Poor burner ground
- Weak flame from dirty burners
How to fix it — step by step
- Replace the air filter and open all registers
- Note whether the furnace short-cycles or drops flame mid-cycle
- Reset power once and observe a full heat cycle
- Call a technician to clean or replace the flame sensor and measure flame current
Parts that commonly fix the 1 + 2 code
- flame sensor - Shop at RepairClinic
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.