Jandy Pool heater CHECK FLOW Error Code

What the CHECK FLOW code means

On Jandy JXi gas pool heaters, CHECK FLOW means the water pressure switch is not sensing enough flow or pressure for the heater to fire safely, so the heater will not start.

Likely causes

  1. filter pump off or not primed
  2. pump pressure too low
  3. dirty pool filter
  4. variable-speed pump set too slow
  5. faulty pressure switch

How to fix it — step by step

  1. Confirm the filter pump is running and fully primed
  2. Clean or backwash the pool filter and empty the pump basket
  3. Check that all valves between the pump and heater are fully open
  4. If you have a variable-speed pump, raise the speed and try again
  5. Reset the heater once and watch whether the message returns
  6. If CHECK FLOW returns with good flow proven, stop and call a pool technician to test the pressure switch

Parts that commonly fix the CHECK FLOW code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Jandy pool heater error codes

See all Jandy pool heater codes & guides →