Goodman Furnace 11 flashes

What this problem usually means

Igniter open on Goodman GMES96-series furnaces. The control sees an open igniter circuit, so the igniter cannot heat up to light the burners.

Likely causes

  1. cracked or burned-out hot surface igniter
  2. disconnected or loose igniter wire
  3. failed igniter circuit on the control board

How to fix it — step by step

  1. Check the thermostat is set to Heat and the furnace power switch and breaker are on
  2. Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
  3. Turn power off for 30 seconds, then back on, and allow one retry cycle
  4. Do not keep resetting a furnace that repeatedly fails to light
  5. If it locks out again, call a licensed HVAC technician and note the code

Parts that commonly fix it

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Goodman furnace problems

See all Goodman furnace codes & guides →