Goodman Furnace 8 flashes

What this problem usually means

Igniter relay fault on Goodman GMES96-series furnaces. The control detected a fault in the igniter relay circuit on the integrated control module.

Likely causes

  1. failed igniter relay on the control board
  2. faulty hot surface igniter circuit
  3. control board failure

How to fix it — step by step

  1. Check the thermostat is set to Heat and the furnace power switch and breaker are on
  2. Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
  3. Turn power off for 30 seconds, then back on, and allow one retry cycle
  4. Do not keep resetting a furnace that repeatedly fails to light
  5. If it locks out again, call a licensed HVAC technician and note the code

Parts that commonly fix it

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Goodman furnace problems

See all Goodman furnace codes & guides →