Frigidaire Washer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 21 codes covered.
Shop Frigidaire Washer parts at RepairClinic
- E1 — Long fill time on a top-load washer: the tub is not filling with water as fast as it should.
- E11 — Fill time too long: the front-load washer did not reach the target water level within the allowed time (about 8 minutes).
- E13 — Water leak in the tub, or an air leak in the water level pressure sensor air hose (air bell).
- E14 — The dispenser drawer is not closed, so the washer will not start or continue correctly.
- E2 — On a top-load washer, water is taking too long to drain from the tub.
- E21 — Water is not pumping out fast enough: the washer drains too slowly and pauses with water left in the tub.
- E23 — The drain pump relay on the main control board has failed, or a wire is off the drain pump.
- E24 — The drain pump relay circuit on the control board has failed, or a wire is off the drain pump (same drain-pump circuit fault family as E23).
- E3 — The washer lid is open or the lid lock has failed, so the washer will not run or spin.
- E31 — The water level pressure sensor is not communicating with the electronic control board, so the washer cannot read the water level.
- E35 — The water level pressure sensor detects an overfill: there is too much water in the tub.
- E36 — The control board itself has a problem and the washer cannot run reliably.
- E4 — The washer is out of balance during the spin cycle and stopped to protect itself.
- E41 — The control board thinks the door switch is open, so the washer will not lock or start.
- E43 — The control detects a problem with the door lock circuit.
- E5 — The top-load washer is not level, which can cause vibration, noise and poor spin performance.
- E52 — Bad signal from the drive motor tachometer: the control cannot read the motor speed correctly.
- E56 — High motor current: the drive motor is drawing too much current, usually because it is overloaded or failing.
- EF1 — The drain pump is clogged, so water cannot leave the tub properly.
- EF2 — Too much soap: the washer detects excess suds from too much detergent or the wrong detergent type.
- F2 — Too many suds: excess foam from too much detergent or non-HE detergent is overflowing or confusing the washer.