Bryant Furnace 12 Error Code
What the 12 code means
Blower on after power up on most Bryant furnaces: if power is restored while the thermostat is calling for heat, the blower runs for about 90 seconds - normal operation, not a fault. Note that on Bryant variable-speed models such as the 355MAV, code 12 instead means blower calibration lockout (calculated blower RPM out of range on two successive attempts; see code 44).
Likely causes
- Power was interrupted and restored during a call for heat
- On variable-speed models: blower speed calculation out of range, often from high duct static pressure
How to fix it — step by step
- On a standard model, wait about 90 seconds - the blower should stop on its own
- Confirm the thermostat is set to Heat and the furnace runs a normal cycle
- Replace a dirty air filter, which also helps a variable-speed blower calibration fault
- If 12 repeats with no power outages, or your furnace is a variable-speed model, call a technician
Parts that commonly fix the 12 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.