Maytag Washer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 28 codes covered.
Shop Maytag Washer parts at RepairClinic
- dET — The detergent cartridge is not detected in the dispenser (select models). If you use single-load doses of detergent, Maytag says this…
- drn — The washer is not draining properly. Maytag notes this can sometimes be an installation problem with the drain hose.
- F0 E2 — Oversuds: suds are preventing the basket from spinning up to speed, or the pressure sensor detects a rising suds level. The control flushes…
- F0 E3 — Overload: the main control detects a load size that exceeds the washer's capacity, or the basket cannot be turned.
- F0 E4 — Spin is limited by water temperature: the water is too high in temperature to spin at final speed, so speed is limited to 500 RPM.
- F0 E5 — An off-balance load has been detected.
- F1 E1 — Main electronic control board failure.
- F3 E1 — Water level pressure sensor fault. The control is not getting a correct water level signal.
- F5 E1 — Lid switch fault: the control thinks the lid switch is in the wrong state for the cycle.
- F5 E2 — The door is not locking properly, so the washer will not start or continue the cycle.
- F5 E3 — Lid unlock fault: the lid lock will not release at the end of the cycle.
- F7 E1 — A motor speed sensing error: the motor cannot achieve the correct speed for the cycle selected.
- F7 E5 — Shifter assembly fault: the main control cannot determine the position of the drive system shifter.
- F7 E7 — The motor is unable to reach the target RPM for the cycle.
- F8 E1 — The washer is sensing a low flow of water and is taking too long to fill (also shown as LO FL or LF).
- F8 E2 — There is a problem with the dispenser system (select models).
- F8 E3 — Overflow condition: the washer is overfilling or the control believes the water level is too high.
- F9 E1 — Drain times are longer than expected, typically over eight minutes.
- HC — The hot and cold inlet hoses have been installed reversed: the cold hose is on the hot inlet and the hot hose is on the cold inlet. The…
- Int — The cycle was paused or canceled. The washer may take 20 to 30 minutes to stop spinning and drain while this code is shown.
- LdL — The lid is not locking, so the cycle cannot proceed.
- LdU — The lid cannot unlock. The washer detects objects on top of the lid preventing it from unlocking.
- lid — The washer lid was left open. If it stays open for more than 10 minutes, the cycle resets and the water in the washer drains out.
- LOC — Control Lock has been activated, so the controls are locked and the washer will not respond to most buttons.
- Ofb — The washer load is out of balance. The washer runs a load-balance correction routine to try to rebalance it.
- PF — The wash cycle was interrupted by a power failure.
- rL — Items were detected in the washer during the Clean Washer cycle (also shown as F34 on some models). The cleaning cycle must run empty.
- Sd — There are too many suds in the washer (also shown as Sud). The washer pauses tumbling and extends rinsing to break down the suds, and it…