Jeep Wrangler Won't start

What this problem usually means

A JK Wrangler that cranks but will not start, or intermittently will not crank at all, has a known electrical suspect: the TIPM (the underhood fuse/relay box), whose internal fuel pump relay can fail. When the relay dies, the fuel pump never runs and the engine gets no fuel, and the failure is often intermittent before it is permanent.

Likely causes

  1. Failed fuel pump relay inside the TIPM
  2. Weak battery or corroded grounds (rule out first; Wranglers live hard lives)
  3. Failed fuel pump itself
  4. Crankshaft position sensor failure

How to fix it — step by step

  1. Load-test the battery and clean the terminals and main grounds first
  2. Listen for the fuel pump priming when the key is turned on; silence plus a healthy battery points at the pump circuit or TIPM relay
  3. Check for fuel pump power at the pump connector with a test light or meter
  4. If the TIPM relay is the cause, options are a TIPM repair/replacement or an external relay bypass kit; confirm the diagnosis before buying a TIPM, as they are expensive

Parts that commonly fix it

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Jeep Wrangler problems

See all Jeep Wrangler codes & guides →