Samsung Dishwasher Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 22 codes covered.
Shop Samsung Dishwasher parts at RepairClinic
- 1E — On WaterWall models this is a clogged filter error: water is not passing through the filter. On rotary spray-arm models 1E/IE means the…
- 3C — Pump operation error: the wash pump has failed or is not operating, so the dishwasher fills but does not begin active washing. Some…
- 3E — High temperature water supply error: the incoming water is too hot. Samsung specifies the hot supply should not be above 176 degrees F.
- 4C — Water supply error: the dishwasher is not getting water at the pressure or temperature it needs. Newer models show 4C and older models show…
- 4E — Water supply error: the dishwasher is not getting water at the pressure or temperature it needs. 4E is the older-model equivalent of 4C.
- 5C — Drain error: the dishwasher cannot drain, and the control sees no drop in water level. Newer models show 5C; older models show the same…
- 5E — Drain error: the dishwasher cannot drain properly. 5E is the older-model equivalent of 5C.
- 7E — WaterWall reflector error: the WaterWall reflector bar is not able to move correctly, so there is little or no spray action from it.
- 9E — Low water level error: there is not enough water in the dishwasher during the cycle.
- AC — PCB communication check: abnormal communication between the main PCB and the sub PCB, so the dishwasher powers on but will not start or…
- AP — Access Point mode: this is not a fault. The dishwasher is in Access Point mode to help connect it to a mobile device / SmartThings.
- BC2 — Button check error, shown as bC2 or bE2: a button has been pressed for more than 30 seconds or the panel thinks a key is held down, so…
- bE — Button error: the control panel detects a stuck button. It is also shown as 6E on some models and as 6C/BE in the UK table.
- CE — Communication error: the control panel is unable to communicate with the rest of the dishwasher.
- HC — High temperature heater error: the temperature inside the dishwasher is too hot. On rotary models this same fault can appear as 1E or IE.
- HE — Heater error: the temperature inside the dishwasher is being detected incorrectly.
- LC — Leakage error: the leak sensor detects moisture in the base, so the dishwasher turns itself on and keeps trying to drain. Newer models show…
- LE — Leakage error: the leak sensor detects moisture in the base and the dishwasher will not turn off while it tries to drain. LE is the…
- OC — Over-level water error: there is more water in the dishwasher than there should be, often linked to a drainage problem. It is also shown as…
- PC — Zone Wash error: the Zone Wash function is not operating correctly. In the Australian table PC/PE indicates the dividing valve is defective.
- PE — Half load function error: the half load function is not performing correctly. In the Australian table PC/PE is listed as a dividing valve…
- tE — Temperature sensor error: the temperature inside the dishwasher is being detected incorrectly, with an open or short in the thermistor…