LG Dishwasher Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 18 codes covered.
Shop LG Dishwasher parts at RepairClinic
- AE — Leak detected (also shown as E1 or EI on some models): water in the base pan has activated the float switch and the dishwasher keeps…
- bE — Bubble error: oversudsing has occurred and the dishwasher displays bE deliberately to prevent leaks.
- Cd — Cool Dry - this is not an error. After a cycle ends, the Keeping/Cool Dry function runs the air blower fan for about an hour to remove…
- CE — Motor error: a problem with the wash motor or the wiring between the motor and the control board. CE is paired with LE on many models -…
- CL — Control Lock (Child Lock) is on - this is not an error. The control panel is locked, buttons cannot be pressed and cycles/options cannot be…
- CR — Test mode - this is not an error. The dishwasher is in the installer/technician test (continuous run) mode used to check the unit's…
- F31 — Heat Dry fan issue (Dynamic Heat Dry models only): the heat dry fan motor does not operate.
- F35 — Heat Dry temperature issue (Dynamic Heat Dry models only): the temperature of the Heat Dry components cannot be measured.
- F37 — Auto Open Door error (models with Auto Open Door): the auto open door feature does not function.
- FE — Overfill error: more water than the standard amount was supplied to the tub. LG groups FE with AE/EI as a leakage/overfilling condition and…
- HE — Heater error: the heater that heats the wash water is malfunctioning and the water supplied to the dishwasher is not being heated.
- IE — Water inlet error: the specified amount of water was not supplied to the tub. The dishwasher is not filling correctly.
- LE — Wash (cleaning) motor error: the circulation/wash motor is not functioning normally. On some models the same motor fault is shown as CE.
- nE — Vario pump issue: the impeller (vario pump) does not spin normally, so wash water is not distributed correctly.
- OE — Water outlet (drain) error: the tub is not fully drained at the end of the drain step.
- PE — Water level sensor error (older models only): the sensor that detects the water level in the tub to prevent leaks has a fault.
- PF — Power failure: power to the dishwasher was interrupted (outage, surge or tripped breaker) during a cycle. This is a protective notice, not…
- tE — Temperature sensor (thermistor) error: the dishwasher has a temperature-sensing fault, such as a sensor contact problem or sensor failure.