Frigidaire Dishwasher Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 12 codes covered.
Shop Frigidaire Dishwasher parts at RepairClinic
- ER — Membrane switch failure: the main control board has detected a stuck key, or a key pressed for more than a minute, on the control panel.
- i10 — A low fill has been detected: the dishwasher did not get enough water to reach the correct level.
- i20 — The dishwasher did not drain properly: water is left in the tub because the drain path is restricted.
- i30 — A leak or overflow of water has been detected in the bottom pan, and the flood protection has shut the dishwasher down.
- i40 — Clogged filters or a restricted drain path: the dishwasher senses the filter or sump is blocked (shown grouped with i20 and iF0 on many…
- i50 — A problem has been detected with the drain or wash motor, so the dishwasher cannot wash or drain correctly.
- i60 — A problem has been detected with the water heating system, so wash water is not reaching temperature.
- iC0 — A problem has been detected with the electronic control system of the dishwasher.
- iF0 — A drain or overflow related fault grouped with i20 and i40 on the Use and Care guide: the dishwasher detects a drain restriction or water…
- PF — Power failure: power to the dishwasher was interrupted or dropped during a cycle.
- UF — Vent failure: the vent fan is running too slowly or has stopped, so drying performance suffers.
- UO — Vent open: during the wash cycle the main control board does not receive a signal that the vent plunger is closed.